Jordan Epstein
10-11-2017, 11:25 PM
I have a new to me Rockwell Unisaw. I purchased this back around 2009 but had it stored in a home in a state I did not live in. I just moved back to this home and am ready own a working Unisaw. It is a 3hp 3 phase motor and I have got the VFD working and the saw spinning up.
I have built two throat plates, gotten a left hand nut, installed a Biesemeyer I had picked up.
I still need to find a motor fan to fit the motor. The old fan is missing all the blades. I removed the set screw on it and the interior is 29/32". The inside of the housing of the motor end cover is 8" diameter. Where should I look for a fan to fit this?
The saw has 3 belts but they seem to be 3 sizes, Where should I look for a set of matching belts? The motor is a Rockwell RW 024.
In the past i have used some gauges and tools to tune my portable contractor saw to a very precise setup. I am under the impression it will be even easier with the Cabinet saw. I can use the loosened saw top and tap it into place to get alignment with the saw blade and miter track. How do i then go about making the saw blade and Biesemeyer parallel?
Thanks in advance for any help. I can't wait to get this saw running and try the nickel test.
I have built two throat plates, gotten a left hand nut, installed a Biesemeyer I had picked up.
I still need to find a motor fan to fit the motor. The old fan is missing all the blades. I removed the set screw on it and the interior is 29/32". The inside of the housing of the motor end cover is 8" diameter. Where should I look for a fan to fit this?
The saw has 3 belts but they seem to be 3 sizes, Where should I look for a set of matching belts? The motor is a Rockwell RW 024.
In the past i have used some gauges and tools to tune my portable contractor saw to a very precise setup. I am under the impression it will be even easier with the Cabinet saw. I can use the loosened saw top and tap it into place to get alignment with the saw blade and miter track. How do i then go about making the saw blade and Biesemeyer parallel?
Thanks in advance for any help. I can't wait to get this saw running and try the nickel test.