Ian Scofield
10-02-2017, 11:36 PM
Trying to clamp these corner braces for my table while doing the glue-up. I was able to push everything together without glue, but now once I add glue to the mix, I'm unable to do it by hand. But because it's weird angles, I'm really struggling to get the right angle to pull them together AND towards the corner. I tried attaching wooden boards to the sides and trying to clamp those together across the joint (parallel to the brace) but that didn't really work and just caused them to arc towards the top and they were no longer square.
Looking to see if anyone has any ideas. I glued one corner and couldn't get the gap to close, which seems to make the joint a lot weaker since it's solely the dominos not the mating surface.
https://s3-us-west-2.amazonaws.com/isco/table/1.JPG
https://s3-us-west-2.amazonaws.com/isco/table/2.JPG
https://s3-us-west-2.amazonaws.com/isco/table/3.JPG
Looking to see if anyone has any ideas. I glued one corner and couldn't get the gap to close, which seems to make the joint a lot weaker since it's solely the dominos not the mating surface.
https://s3-us-west-2.amazonaws.com/isco/table/1.JPG
https://s3-us-west-2.amazonaws.com/isco/table/2.JPG
https://s3-us-west-2.amazonaws.com/isco/table/3.JPG