Delta drill press spindle parts

[Gary McNair]

I've lost the contact info for a company that deals in older/vintage shop replacement parts. My Delta drill press has a plate on the side that reads 43-7525. The upper spindle bearing seems to have gone south. It has a sleeve/collar pressed into it which seems to be a part of the bearing.

Appreciate any leads or contact info for this company.

Thks,
Gary
Granbury, TX

[Frank Martin]

Hammerscale dot com may be the place that can help. Good luck.

[Bill Dufour]

If this is an extended inner race bearing good luck. On my walker turner 15" dp the upper bearing was like that . the engraved bearing number only refered to the outer race. I had to use a similar bearing with a bigger inner bore. and make a sleeve to fit. I think the outer race diameter was increased as well so the casting had to be bored to fit as well.
A easier method would have been to make an oil lite bearing.
Bil lD.

[Walter Plummer]

I recently finished my Walker Turner and Lynne at Accurate Bearings actually sourced them for me but they were expensive. $40.00 each. She deals with everyone over on the OWWM and Vintage machinery sites.