laser acts like rotary is still attached

[TAMI WILSON]

Removed the rotary turned on my laser and am trying to laser flat acrylic. Job control acts like the rotary is still attached.
i removed the rotary from the setup before sending the file but it still shows up and won't let me put my design on the page.
i reinstalled and removed the rotary. always have laser in off position as i know not to unplug when the laser is on.
rebooted computer.

any ideas?????

[Kev Williams]

Not sure if this is an issue with JC, but did you resize the work area so it's not based on a cylinder and pi?

[Tony Lenkic]

When you say you removed rotary from setup did you do following?

Go to OPTIONS/HARDWARE/ACCESSORIES/ and uncheck ROTARY box.