Dave Squires
09-25-2017, 4:28 PM
Hello,
I built a console table and have a drawer on the top which I'm using Blum Tandem with Bluemotion drawer slides. I've been fiddling with it quite a bit but one side tries to pull in (retract) when fully extended. So essentially when you pull all the way out, the right side automatically pulls in some. I've re-measured everything. The slides are parallel, same amount extracted, both slides are fully engaged in the front locks. I'm just not sure what would cause this. Any ideas what I could check?
Thank you!
I built a console table and have a drawer on the top which I'm using Blum Tandem with Bluemotion drawer slides. I've been fiddling with it quite a bit but one side tries to pull in (retract) when fully extended. So essentially when you pull all the way out, the right side automatically pulls in some. I've re-measured everything. The slides are parallel, same amount extracted, both slides are fully engaged in the front locks. I'm just not sure what would cause this. Any ideas what I could check?
Thank you!