Torsten Fassbender
09-14-2017, 7:12 AM
Hey Guys
I have a question about laser engraving.
- Machine LXJ 9060
- Controller Leetro MPC 6585
when i engrave for example a triangle (20mm wide and 20mm high)
Than the the X movement goes always full range (20mm) even when it comes to the small part of the triangle.
I saw on some videos, that the X movement gets smaller, when the figure gets smaller.
I dont know how to explain it better.
My question is:
-Is that just a setup to do in the controller or some where?
-Is it possible with the controller i have ?
Thank in forehand
Torsten
I have a question about laser engraving.
- Machine LXJ 9060
- Controller Leetro MPC 6585
when i engrave for example a triangle (20mm wide and 20mm high)
Than the the X movement goes always full range (20mm) even when it comes to the small part of the triangle.
I saw on some videos, that the X movement gets smaller, when the figure gets smaller.
I dont know how to explain it better.
My question is:
-Is that just a setup to do in the controller or some where?
-Is it possible with the controller i have ?
Thank in forehand
Torsten