Tim M Tuttle
09-09-2017, 3:48 PM
Afternoon all,
I have a SawStop contractor saw (got it a few months ago) but never really checked the tuning on it all that closely so today I decided to check all the different alignments; fence to table, table to blade, fence to blade, etc. Everything checks out except for the table to the blade of which adjustment appears to be a cumbersome endeavor. I looked around a bit online to find some articles or videos on aligning a contractor saw but didnt find tons of help.
Am I going to need to remove the rails and wings to get this thing lined up? I watched one video where a guy removed the top completely. Right now the blade is .009 out of alignment front to back. I believe I want to get down to .002, is that correct?
Thanks for your help.
I have a SawStop contractor saw (got it a few months ago) but never really checked the tuning on it all that closely so today I decided to check all the different alignments; fence to table, table to blade, fence to blade, etc. Everything checks out except for the table to the blade of which adjustment appears to be a cumbersome endeavor. I looked around a bit online to find some articles or videos on aligning a contractor saw but didnt find tons of help.
Am I going to need to remove the rails and wings to get this thing lined up? I watched one video where a guy removed the top completely. Right now the blade is .009 out of alignment front to back. I believe I want to get down to .002, is that correct?
Thanks for your help.