Alden Foy
08-25-2017, 9:33 AM
Looking for any additional ideas on troubleshooting my problem. I have a ULS V460 that has a 30W laser tube newly recharge that is producing low power (about 50% of setting).
I've replaced mirrors and lens. Alignment has been checked and rechecked. I also have a ULS M300 that has a 30W also and I've swapped laser tubes and the problem stays
with the V460. Took the CPU out of the V460 and sent it off to ESS and they voltage checked it and states that everything is fine. I've check the voltage going into the
laser tube and that also measures as it should. My next option is to sent the CPU to Universal and just have them completely go thru it for $250 but wanted to see if there
are any other ideas before I spend the money. In the attached pic, the top one is from the V460 and the bottom one is the M300, but using the same settings. To get the
V460 to look like the M300 I have to double the power settings. Thanks
366716
I've replaced mirrors and lens. Alignment has been checked and rechecked. I also have a ULS M300 that has a 30W also and I've swapped laser tubes and the problem stays
with the V460. Took the CPU out of the V460 and sent it off to ESS and they voltage checked it and states that everything is fine. I've check the voltage going into the
laser tube and that also measures as it should. My next option is to sent the CPU to Universal and just have them completely go thru it for $250 but wanted to see if there
are any other ideas before I spend the money. In the attached pic, the top one is from the V460 and the bottom one is the M300, but using the same settings. To get the
V460 to look like the M300 I have to double the power settings. Thanks
366716