steven c newman
08-05-2017, 7:16 PM
Wasn't enough room in the shop today, to use the corded stuff...
365361
Had a Walnut board that needed cut down...
365362
Got three pieces altogether, Needed one edge jointed straight..
365363
Towards the end of a 5 hour day...didn't feel like using the #8 Jointer, so..
365364
Stanley No. 6c, T-10 seemed to do ok..
Needed a rebate along an edge or two..
365365
Set up a "plough plane" to do the job
365366
To make it a stopped rebate, I had to use a mallet and chisel....
Busy day today.....:D
365361
Had a Walnut board that needed cut down...
365362
Got three pieces altogether, Needed one edge jointed straight..
365363
Towards the end of a 5 hour day...didn't feel like using the #8 Jointer, so..
365364
Stanley No. 6c, T-10 seemed to do ok..
Needed a rebate along an edge or two..
365365
Set up a "plough plane" to do the job
365366
To make it a stopped rebate, I had to use a mallet and chisel....
Busy day today.....:D