Todd Mueller
07-28-2017, 10:44 AM
I just received a new chinese laser cutting, 100watt co2, and the first time i turned it on the display worked perfectly,
after i turned it off, and then back on the display glitches out with lots of goofy lines and such and is not readable in most areas.
i have left it unplugged for extended periods of time, and each time it is still messed up
i checked most of the connections in the cast between the control display and the key swith and power and ma gauges, and they all seem to be tight and good from what i can tell.
any ideas on how to "reset" it or something to see if i can get it working, i have not even been able to try and cut with the machine yet due to the display acting up.
it works with rdcam software
after i turned it off, and then back on the display glitches out with lots of goofy lines and such and is not readable in most areas.
i have left it unplugged for extended periods of time, and each time it is still messed up
i checked most of the connections in the cast between the control display and the key swith and power and ma gauges, and they all seem to be tight and good from what i can tell.
any ideas on how to "reset" it or something to see if i can get it working, i have not even been able to try and cut with the machine yet due to the display acting up.
it works with rdcam software