Jason Winterrowd
07-27-2017, 11:00 AM
I just installed my Incra TS LS and am setting everything up. I have a Woodpeckers saw guage with dial indicator and I squared my fence to the miter slot. The fence is completely square at the front and rear but has a hump in the middle that measures 5/1000 on the dial indicator. Is this within tolerance or will it have much effect on my results?
I am just a novice and purchased the fence to increase my accuracy and I dont want to contact Incra with a silly complaint. I purchased the Woodpeckers guage a year ago and get a little obsessive with trying to set up and measure the preciseness of my tools and find myself wondering what is "good enough".
My question is if this is a non-issue.
I am just a novice and purchased the fence to increase my accuracy and I dont want to contact Incra with a silly complaint. I purchased the Woodpeckers guage a year ago and get a little obsessive with trying to set up and measure the preciseness of my tools and find myself wondering what is "good enough".
My question is if this is a non-issue.