Joel Wesseling
05-29-2017, 11:23 AM
I'd like to get the slider working smoother and more accurately. The picture shows the parts that need to be replaced.
The 3 lower rollers has bearings labelled 4BPPL RIV. I need them replaced providing I can get them apart without destroying anything.
The 3 taperred guide rollers has the marking 13281 64.RIV
There is 3 brass set screw bushings.
I'm sure it will be hard, if not impossible, to find all replacement parts, but hoping to find help here.
Wondering about reworking the sliding table with a new system. Any ideas?
I'm also considering the purchase of a new Felder Saw-shaper but not crazy about spending $12K for B3 Winner Comfort. This model insures the ability to handle full size sheets.
If I keep the SCM I would purchase Felder Shaper. The F3 is about $6 and then I would have an independent shaper.
Not certain if working on the Si15 is worth the trouble and cost. The slider works now but it is quirky and want sliding table improvements.
I also will need a new 4-5HP motor for the SCM, could be $700 or more.
Fix the SCM and how? Purchase new and sell SCM?
Thanks for all advice in advance>
The 3 lower rollers has bearings labelled 4BPPL RIV. I need them replaced providing I can get them apart without destroying anything.
The 3 taperred guide rollers has the marking 13281 64.RIV
There is 3 brass set screw bushings.
I'm sure it will be hard, if not impossible, to find all replacement parts, but hoping to find help here.
Wondering about reworking the sliding table with a new system. Any ideas?
I'm also considering the purchase of a new Felder Saw-shaper but not crazy about spending $12K for B3 Winner Comfort. This model insures the ability to handle full size sheets.
If I keep the SCM I would purchase Felder Shaper. The F3 is about $6 and then I would have an independent shaper.
Not certain if working on the Si15 is worth the trouble and cost. The slider works now but it is quirky and want sliding table improvements.
I also will need a new 4-5HP motor for the SCM, could be $700 or more.
Fix the SCM and how? Purchase new and sell SCM?
Thanks for all advice in advance>