Brian Sommers
05-16-2017, 6:08 PM
With the help of my strong wife I stood the bandsaw up for the first time after getting it home yesterday late afternoon.
I’m waiting now at this point until my new Timber Wolf 3/4” 2-3tpi blade arrives tomorrow to set everything up.
I was checking the fence that came with it and noticed it was slightly concave. the bottom and top edges were on but the middle sunk in a bit. It seems by design and not by error.
Should it be this way or not? I can see if the piece your sawing is tall enough to touch the top part of the fence I feel everything would be fine, but if it’s shorter then it would “lean” back resulting in a slanted resawn cut.
Unless I’m missing something here, please advise.
thanks
I’m waiting now at this point until my new Timber Wolf 3/4” 2-3tpi blade arrives tomorrow to set everything up.
I was checking the fence that came with it and noticed it was slightly concave. the bottom and top edges were on but the middle sunk in a bit. It seems by design and not by error.
Should it be this way or not? I can see if the piece your sawing is tall enough to touch the top part of the fence I feel everything would be fine, but if it’s shorter then it would “lean” back resulting in a slanted resawn cut.
Unless I’m missing something here, please advise.
thanks