Marc Ward
10-21-2005, 9:52 PM
I am getting a new table saw on Monday. It is a Jet 3 horse, single phase, 230v cabinet saw. The saw comes WITHOUT a plug, there are three wires (black, green and white, I think).
I do not have a 23v outlet in my basement, but I just switched from a electric water heater to gas, so there is conduit run to where the old water heater was with wires sticking out. I assumed this was 230v...but there is only two wires in the metal conduit, very thick red and black. I was expecting three wires.
Is this 230v, and can I use it for my new saw? Oh, I also got a new dust collection system that is also 230v and I will need to run both machines at the same time. Any suggestions?
Thanks for your help.
I do not have a 23v outlet in my basement, but I just switched from a electric water heater to gas, so there is conduit run to where the old water heater was with wires sticking out. I assumed this was 230v...but there is only two wires in the metal conduit, very thick red and black. I was expecting three wires.
Is this 230v, and can I use it for my new saw? Oh, I also got a new dust collection system that is also 230v and I will need to run both machines at the same time. Any suggestions?
Thanks for your help.