View Full Version : Serious Lathe DOA
Dale Winburn
05-10-2017, 4:45 PM
I have a friend with a Serious Lathe that just quit. The VFD seems completely dead, no error codes, no nothing. Does anyone have any ideas? Does A VFD have fuses inside? He was coring a 12" bowl blank when it happened. I will be going to his shop Friday so I can check anything.
Thanks for any help and suggestions,
Dale Winburn
Roger Chandler
05-10-2017, 5:34 PM
Dale, an email to Scott Trumbo will yield proper input on this .....also Tom Zepada in Front Royal is now an East Cost Serioius representative for Serious. Scott is a standup guy, and will do all he can to help.....he values his customers and the Serious Toolworks reputation.
His email is trumbo1@comcast.net
John King
05-11-2017, 11:53 AM
Call the lathe or VFD vendor for advice/troubleshooting. In my opinion, they provide the most reliable information. - John
Olaf Vogel
05-11-2017, 12:15 PM
I assume you checked for the obvious with a multimeter?
- power from the wall
- all wires connected to the VFD
- fuses, if any
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.