ron david
05-06-2017, 10:59 PM
was asked to turn a pattern bell shaped end for an 8" fibreglass pipe or tube; marine use was given measure of 17 3/4" dia across the top, down 2" and then a 4 7/8" radius and theh another 2" drop for inside the pipe.
used most of a 28BF poplar plank. 10/4 x 9" x 15'
http://imagizer.imageshack.us/v2/1600x1200q90/924/LowqDw.jpg
http://imagizer.imageshack.us/v2/1600x1200q90/922/bXqzDW.jpg
http://imagizer.imageshack.us/v2/1600x1200q90/923/CggWKZ.jpg
https://www.youtube.com/watch?v=hvZx0oggmMQ
https://www.youtube.com/watch?v=EXVlam_Mzdw
ron
used most of a 28BF poplar plank. 10/4 x 9" x 15'
http://imagizer.imageshack.us/v2/1600x1200q90/924/LowqDw.jpg
http://imagizer.imageshack.us/v2/1600x1200q90/922/bXqzDW.jpg
http://imagizer.imageshack.us/v2/1600x1200q90/923/CggWKZ.jpg
https://www.youtube.com/watch?v=hvZx0oggmMQ
https://www.youtube.com/watch?v=EXVlam_Mzdw
ron