Another Segmented Turning

[Ed Morgano]

359642359643359644

This one is the same size as the last one. 7 1/2" Diameter by about 14" tall.

[Dane Riley]

I've never seen anything like the ogee curves on the neck. How did you do that?

[Ed Morgano]

Dane, I have a CNC router that I used for that part. That was my third try. I finally ended up turning it to it's shape to cut the ogee's. It was too delicate to turn the shape after I cut the ogee slots, but I didn't figure that out until the third try. :)