Sarah Dixon-Smith
05-02-2017, 2:19 AM
Hi
I have an Inca Jointer, not sure of the model number as it has lost its plate.
We are struggling to set the knife height. There are 2 sets of screw holes in the drum, the larger ones to tighten the blades are fine. However, the smaller ones where you would expect to find adjustment screws are empty, in addition there doesnt seem to be a thread to take any screws.
any thoughts?
thanks
I have an Inca Jointer, not sure of the model number as it has lost its plate.
We are struggling to set the knife height. There are 2 sets of screw holes in the drum, the larger ones to tighten the blades are fine. However, the smaller ones where you would expect to find adjustment screws are empty, in addition there doesnt seem to be a thread to take any screws.
any thoughts?
thanks