Ian Stewart-Koster
04-24-2017, 6:16 AM
Tonight, I ran three files, and what is very weird, is that a simple star file to be cut in acrylic I sent, with settings/speeds in Corel were Power=30, Speed=2, PPI=1000, from memory.
The M300 console showed them as P=0, S=0, PPI=0, and did nothing.
The next file tried - same problem. Swapped the cable (LPT lead) and no difference.
I'm wondering what could be deleting the setting figures?
Time for another shutdown and reboot of the PC. I did reboot the laser, four times, and that made no difference.
Any suggestions would be welcomed! Thanks.
The M300 console showed them as P=0, S=0, PPI=0, and did nothing.
The next file tried - same problem. Swapped the cable (LPT lead) and no difference.
I'm wondering what could be deleting the setting figures?
Time for another shutdown and reboot of the PC. I did reboot the laser, four times, and that made no difference.
Any suggestions would be welcomed! Thanks.