View Full Version : Applying Wipe on Poly(ArmrSeal) with item being finished in the verticle position??
George Bokros
04-23-2017, 4:39 PM
Can this be done successfully or is it better to have it in a horizontal position?
Thanks
John TenEyck
04-23-2017, 6:58 PM
Wipe away, George. Arm-R-Seal is never applied thick enough to run, or shouldn't be, so orientation is not a factor. It might be physically easier to work on something when it's horizontal, but it's not a requirement.
john
George Bokros
04-23-2017, 7:02 PM
Thanks John. I figured you would chime in and have an answer.
John TenEyck
04-23-2017, 9:57 PM
You know, doing a piece vertically is a good teacher for how thin you should apply Arm-R-Seal. If it sags or runs, it's not thin enough.
John
Andy Giddings
04-23-2017, 11:28 PM
+1 on all of John's wisdom - nice thing about using blue shop towels with Arm R Seal is the towel doesn't adsorb much, so vertical surfaces should be a breeze
Bill McNiel
04-24-2017, 10:05 AM
I do it all the time, no problem.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.