what clamp is that

[Steven Lee, NC]

the red handled one sticking out the top.

All the ones I've seen like that won't fit a 3/4" hole 3-4 inches deep....thanks


358504

[Michael Rector]

It's this guy

http://www.rockler.com/sjobergs-st11-holdfast-3-4inch-lug

[Lewis Justis]

It is made for that bench (Sjoberg Elite) with 1" diameter dog holes in a top that is about 3-1/2" thick.

[Steven Lee, NC]

thanks, thought it was some sort of bar clamp

[Jim Becker]

It is made for that bench (Sjoberg Elite) with 1" diameter dog holes in a top that is about 3-1/2" thick.
Yes, that's an important point...there are only a couple of dedicated holes for that particular clamp in the Sjoberg bench (I had one before getting my Noden Adjust-a-Bench). There are a number of alternatives available today if you want an actual clamp as well as traditional hold-downs. I honestly get a lot of mileage out of my hold-downs, even in assembly work, not just when working components on the bench.