View Full Version : Nova DVR XP
Bill Blasic
04-13-2017, 6:19 AM
If you have a Nova DVR and always desired a speed knob you are now in luck. I did an article for More Woodturning Magazine that shows this XP Upgrade Panel Kit. It does a lot more than just give you a speed knob, check it out.
Robert Willing
04-13-2017, 9:55 AM
OK where is the link?
Michael Schneider
04-13-2017, 10:12 AM
https://www.morewoodturningmagazine.com/ I subscribed last year based on the articles mentioned in the forum. I always look forward to each new edition.
Ralph Lindberg
04-13-2017, 8:16 PM
If you have a Nova DVR and always desired a speed knob you are now in luck. I did an article for More Woodturning Magazine that shows this XP Upgrade Panel Kit. It does a lot more than just give you a speed knob, check it out.
Only if you have Ver 6 (or newer) of the software. If you have Ver 4 (like my 10 year old lathe) you need a new mother board at $400, plus the new control panel.
sigh... $550 is probably not worth the knob and 10 speed memories
John Grace
04-13-2017, 8:18 PM
While I surely would like a turn knob speed control for my NOVA...$550 is just too steep for the convenience. I guess I'll just save that for my next lathe...
Ralph Lindberg
04-13-2017, 9:09 PM
If you have version 6 or newer, it's only $150
Robert Willing
04-13-2017, 9:12 PM
Oh well no big deal, just curious. I had the Beta up grade for the 16-24 back in 2012 and sold it in 2015 for a Grizzly 0766.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.