Brand new 30w Fiber, marking box is off! Can anyone help?

[Michael Carter Jr.]

Hey folks,

Mike Carter here, thank you for letting me join! I have been thinking about buying a fiber for a while, and finally took the plunge with a 30w Chinese fiber laser. I have a lot to learn, and this place has tons of info! Anyway, I'm set up, EZcad running, making marks in metal, the whole bit. My only issue at this point is that the laser marks outside the box, below and to the left. I looked through the manual, and I cannot find a way to adjust it. Anyone have any ideas?

Thank you for your help!

Ps-the pic is horrible, sorry about that.

[Scott Shepherd]

Go into Parameters at the bottom of the home page, and click through the tabs. I think it says "Other" at the tab (maybe not), click "Red Dot Pointer" and it'll have a set of dimensions you can move around to get it in the right place.

[Michael Carter Jr.]

Worked like a charm, Thank you!!!!

[Bill George]

Scott you always amaze with your depth of knowledge!
I learned something that maybe I can use sometimes. Thanks for posting.

[Scott Shepherd]

Scott you always amaze with your depth of knowledge!
I learned something that maybe I can use sometimes. Thanks for posting.

Thanks Bill, much appreciated. Now, if I could remember where I put my car keys, that would he helpful :D

[Dave Sheldrake]

I got 5 Galvo's Scotty and I never knew that :) nice one brother :)

[Scott Shepherd]

WOW! I actually helped Dave! I can die now, my work here is done ;) I never thought that day would come!