PDA

View Full Version : Fiber Lens setup



Kristian Matz
04-06-2017, 12:09 PM
I received a 200x200 lens in addition to the 110x110 that came installed on my machine. Ray Fine sent me what I assume is a configuration file for the 111 lens, but not for the 200. Does anyone have instructions on what I need to do to get the 200x200 setup?

I have sent in a request to Ray Fine about this, but if its something easy any help is appreciated.

Thank you

John Lifer
04-06-2017, 2:00 PM
I'll send to you in a minute

John Lifer
04-06-2017, 2:33 PM
Darn it Kristian I've a 100 and 150mm, not 200. Are you sure it wasn't on the USB drive that came with machine? or was yours completely set up?
Not that many changes, under system parameters, workspace size would change to Height 200 and Width 200 and you can put the corner where you want.
But you do need configuration parameters (F3) under field tab. the two scale settings are larger on my 150 vs 100.
But you Could use handbook and figure these settings out..... I had to change my x setting up a few thousandths in order to get dimensions correct. Handbook lays out the procedure.
And nothing else changes. (focal height, but you can figure that out pretty close too with red dot and cutting)
Sorry, maybe someone else has it.