stan kern
03-31-2017, 1:34 PM
did some research into family coat of arms and found how to combine 2 nationalities on one plaque
Its a lot of work getting the components together takes about 1.5 hrs to get the graphics all set up
and do the node editing
This could also be run on the cnc router , using a fine end mill or v50 degree bit
https://youtu.be/V6piNa2ye3E
Its a lot of work getting the components together takes about 1.5 hrs to get the graphics all set up
and do the node editing
This could also be run on the cnc router , using a fine end mill or v50 degree bit
https://youtu.be/V6piNa2ye3E