April Murphy
03-27-2017, 9:02 PM
Hi
I am a new user here and I hope I have put this question in the right spot. I do apologise if I have not.
I own a 60W Chinese Laser Cutter. I have recently used the rotary for the first time. After I first set it up, I went to frame my job and the axis bar jammed itself up against the edge and made a loud noise. I am not sure if I have damaged something or not. Now when I try to use the laser for normal cutting or engraving it seems as though the Y axis is not working properly. The job will start as normal but the Y axis will barely move. The job comes out squished into a 1/3 or less of its proper size. To add to this my interface (control panel) on the machine itself, is not working. The screen lights up but you cant see anything. So this makes resetting anything on the actual machine very difficult. Do I need to configure the settings in RDWorks? Can anyone help me?
I am a new user here and I hope I have put this question in the right spot. I do apologise if I have not.
I own a 60W Chinese Laser Cutter. I have recently used the rotary for the first time. After I first set it up, I went to frame my job and the axis bar jammed itself up against the edge and made a loud noise. I am not sure if I have damaged something or not. Now when I try to use the laser for normal cutting or engraving it seems as though the Y axis is not working properly. The job will start as normal but the Y axis will barely move. The job comes out squished into a 1/3 or less of its proper size. To add to this my interface (control panel) on the machine itself, is not working. The screen lights up but you cant see anything. So this makes resetting anything on the actual machine very difficult. Do I need to configure the settings in RDWorks? Can anyone help me?