Delta 12-14 tablesaw base dimensions

[Bill Dufour]

Any one know the base dimensions of the Delta/Rockwell 12-14 tablesaw. I would like to replace my Unisaw with one of those sometime. I need to weld up a new mobile base for the Unisaw and I figure if it is a few inches bigger I can use it latter under a 12-14 saw.
Bill D.

[Dave Cav]

I'd go out and measure mine, but it's 850 miles away. If you don't get an answer here, go over to OWWM and someone there can measure theirs.

[Leonard King]

I can measure in the morning I have a unisaw and we have a older 12-14 at work. it wont be a few inched larger. I'm thinking the cabinet base is more like 50% bigger both ways. 32-36", but i couldn't be sure till i measure.
L.T.

[Matt Day]

Just go with "a lot bigger than your Unisaw".

[Leonard King]

So 33" wide and 27" depth. I don't have the unisaw measurement but it's just under 24 x 24 i think.

[Bill Dufour]

Well that plan is out. My unisaw is roughly 21" square at the base. So quite a bit smaller.
Bill D.