Paul Rodgers
03-22-2017, 10:39 PM
Hi,
I work at an Australian Company which uses a Kern 400HSE Laser to cut sheet acrylic. Usually we run cuts through CorelDraw x6 and KCAM software which works fine and rarely causes issues. However recently I have learnt that we can cut pre-printed acrylic sheets using i-cut 7 because our laser has the K-vision camera installed. The problem is that the laser was installed before I began working at the company and nobody here has received any training or has any idea how this process works.
We have an upcoming job which has the potential to become between 8000-20000 separate pre-printed panels which I will have to cut and using CorelDraw to do this, while possible, will be an absolute nightmare.
So my question is simple, is there some dark depth of the internet which has training videos or manuals to help me understand and run i-cut 7 or am I up a certain creek without a paddle?
I work at an Australian Company which uses a Kern 400HSE Laser to cut sheet acrylic. Usually we run cuts through CorelDraw x6 and KCAM software which works fine and rarely causes issues. However recently I have learnt that we can cut pre-printed acrylic sheets using i-cut 7 because our laser has the K-vision camera installed. The problem is that the laser was installed before I began working at the company and nobody here has received any training or has any idea how this process works.
We have an upcoming job which has the potential to become between 8000-20000 separate pre-printed panels which I will have to cut and using CorelDraw to do this, while possible, will be an absolute nightmare.
So my question is simple, is there some dark depth of the internet which has training videos or manuals to help me understand and run i-cut 7 or am I up a certain creek without a paddle?