Benchtop Sawing Vise

[Don Orr]

I recently built a version of the benchtop sawing vise AKA Moxon vise. Built out of Cherry and Maple and some metal bits. Screws are 3/4" Acme thread through captured nuts. About 4 1/4" tall, 24" wide with usable width of 15" and opens to about 4" deep. Not perfect but it works.


356408356407

[Kris Cook]

Don - that looks good. Where did you get the screw and nut hardware?

[Bill McNiel]

Nicely done Don. Me likey.

[Jim Koepke]

Nice bench accessory.

jtk

[Phil Mueller]

Well done, and very nice looking, Don. Love the cherry and maple combo.

[David Eisenhauer]

Nice Don. Kris: I was able to source Acme thread, Acme nuts (hex shaped) and some wheel-type handles for my Moxon build from McMaster Carr. I believe that the McMaster Carr shipping ticket showed up somewhere in my shop a few days ago and I may be able to provide part numbers if you need me to tomorrow.

[Andrew Pitonyak]

Really nice! Would have liked to see some build pictures. Sweet!

[Kris Cook]

Thanks David. I will look it up and let you know if I need more info. Appreciate the response.

[Don Orr]

I got the Acme rod and nuts from Enco-now MSC Direct. I bought metal hand wheels at the same time but they ended up being a little too big for the boards I had to work with so I just turned my own.
Thanks for all the nice comments.

[Kris Cook]

Thanks Don. I will check it out.

[Chris Hachet]

Very well done, building a Moxon vise myself is on my to do list....