Joe Beaulieu
03-17-2017, 5:45 PM
Hi,
I have a very nice old bench - a Diefenbach, that I bought about 15 years ago when I just started to get into WW. I love the bench - it is all European Beech and is as solid as a rock. I am not so crazy about the front vise however. It seems very slow to open and close - no quick release obviously, but the screw size on the main shaft seems too fine for a vise, and I spend my time cranking that damn thing in and out. To remedy this I bought a Wilton 79A Woodworking vise to mount on the front of the bench. This is a really nice vise, that provides quite a bit of flexibility with quick release action, an articulating vise face, a full length pop up dog in the outer face, and other features. The best feature is the very beefy build - this thing is solid!
I am trying to figure out how I want to mount this thing. Do I relieve part of the front face of the bench to allow the back plate of the vise to site even with the bench front, or do I leave the existing bench untouched and mount it proud. Do I alter the bench, or do I live with the stand off and adapt how I work to the new position of the vise. I am leaning toward routing out the front apron of the bench and fitting the vise to be flush with the front. What do you think? Anyone done the opposite and let the vise stand proud? What are your regrets and advantages of installing that way? I would really appreciate your feedback!
Thanks
Joe
I have a very nice old bench - a Diefenbach, that I bought about 15 years ago when I just started to get into WW. I love the bench - it is all European Beech and is as solid as a rock. I am not so crazy about the front vise however. It seems very slow to open and close - no quick release obviously, but the screw size on the main shaft seems too fine for a vise, and I spend my time cranking that damn thing in and out. To remedy this I bought a Wilton 79A Woodworking vise to mount on the front of the bench. This is a really nice vise, that provides quite a bit of flexibility with quick release action, an articulating vise face, a full length pop up dog in the outer face, and other features. The best feature is the very beefy build - this thing is solid!
I am trying to figure out how I want to mount this thing. Do I relieve part of the front face of the bench to allow the back plate of the vise to site even with the bench front, or do I leave the existing bench untouched and mount it proud. Do I alter the bench, or do I live with the stand off and adapt how I work to the new position of the vise. I am leaning toward routing out the front apron of the bench and fitting the vise to be flush with the front. What do you think? Anyone done the opposite and let the vise stand proud? What are your regrets and advantages of installing that way? I would really appreciate your feedback!
Thanks
Joe