PDA

View Full Version : Trouble with speed and power with my 50 w china laser



DANNY RIOS
02-23-2017, 3:07 PM
Hi guys.. I'm new to the engraving world but what I have found is that when i scan an image to the yeti cup it comes out with streaks throughout the whole scan any insight on this? What can I be doing wrong?

I guess what I am trying to say is that it doesn't completely erase all the image like on the preview. Speed is 100 power 65

John Lifer
02-23-2017, 10:52 PM
If consistent, then what do you have the scan gap set on? I use 0.08 for most work. Small the number, the closer the lines.

Bill George
02-24-2017, 9:52 AM
First are you using a standard CO2 laser or a Fiber machine? Cermark or not? Did you set it up and try on a inexpensive whatever instead of a $30 Yeti cup and how were those results? I don't understand Erase like preview?
What machine, what brand, power?

Lots of variables before anyone can give you an intelligent answer. The Search command on here will save everyone a Lot of time.

DANNY RIOS
02-27-2017, 7:28 PM
I will try that thank you for your reply