Matt Williams 407
02-06-2017, 9:38 PM
353375353377
Hello everyone, I'm hoping somebody can help with a frustrating issue. I'm getting an unusual double line effect with the laser but only on thin straight objects where the line runs on the Y axis. On the + sign the lines are identical in the file, and if it is rotated 90 degrees it will still only be the segment that is aligned with the Y axis where I get this effect. These examples were cut with the work piece mounted on a rotor, but it still occurs when using the laser normally. On most materials the effect isn't very visible, but with Cermark it is glaringly obvious. The machine is a Boss Laser with a 100 watt glass tube, used with Laser Works V8 software.
Any insight? Thanks.
Hello everyone, I'm hoping somebody can help with a frustrating issue. I'm getting an unusual double line effect with the laser but only on thin straight objects where the line runs on the Y axis. On the + sign the lines are identical in the file, and if it is rotated 90 degrees it will still only be the segment that is aligned with the Y axis where I get this effect. These examples were cut with the work piece mounted on a rotor, but it still occurs when using the laser normally. On most materials the effect isn't very visible, but with Cermark it is glaringly obvious. The machine is a Boss Laser with a 100 watt glass tube, used with Laser Works V8 software.
Any insight? Thanks.