PDA

View Full Version : Cannot Vector



Jim Beachler
01-13-2017, 5:07 PM
Hello. I have several drawings that I have used for years that are set for vector engraving. However, when I now send the drawing to the ULS laser, the drawing comes out in light black and the machine starts to raster the drawing. This can work but is much slower than vectoring.

Checked the drawing to make sure the lines are the proper size and color. Yes they are
Checked Corel 12 program to ensure that the drawing is not going out in grayscale. Yes it is going out in color.
Checked that the settings on the laser are to vector blue and red lines. Yes it is set that way.

What else am I missing??


Thanks, Jim

Ross Moshinsky
01-13-2017, 5:27 PM
Verify it's in RGB and it's the correct RGB color. Worst case scenario, make black a cut line

AL Ursich
01-14-2017, 4:00 PM
When you view layers are they all set to print?

Jim Beachler
01-14-2017, 4:53 PM
Yes, Yes Yes!

Thanks, Ross.
Must have clicked the cmyk button unknowingly.
Now that it is set for RGB it is working again.

Thanks.