Keith Outten
11-13-2016, 12:19 PM
I have needed to make one of these wrenches for a long time and finally found the time. The truth is that my fingers don't work as well as they have in the past and its difficult sometimes to get the GoPro fasteners to loosen up.
Not much to brag about but I can share that I used 1/4" thick cast acrylic because its much tougher than extruded acrylic and will stand up the job at hand. I learned a couple years ago that I could use cast acrylic for router templates after many attempts to use extruded which melted frequently from the friction of the bearing on the router bit.
These will make inexpensive gifts for some of my friends. Anyone who would like the Corel Draw file let me know and I will upload it here.
347396
Not much to brag about but I can share that I used 1/4" thick cast acrylic because its much tougher than extruded acrylic and will stand up the job at hand. I learned a couple years ago that I could use cast acrylic for router templates after many attempts to use extruded which melted frequently from the friction of the bearing on the router bit.
These will make inexpensive gifts for some of my friends. Anyone who would like the Corel Draw file let me know and I will upload it here.
347396