steven c newman
10-14-2016, 11:56 AM
Or a way to move them to where I lived, had to just take a few photos( didn't even have a tripod with me) and hope for a better day.
345743
Smaller one did have a motor with it. The other ran off a line shaft
345744
Behind this scrollsaw, there is a part from the line shaft, that also ran this little guy..
345745
American Tool Works, from Cincy, OH Thred box might have held more tooling?
345746
It had a metal working style to it, though..
345747
I didn't even have the room for this...
345748
Nor it's grinder. I did managed to get a few hand tools. Estate sale, in-between my monthly SSI check, of course:mad:
Seems the fellow had quite a shop going on, the garage had two floors/levels. Shelves were filled with handtools of all kinds.
The day I took these pictures, a fellow pulled up with a Bobcat loader on a trailer. He was after the air compressor....large enough he NEEDED the forks on the bobcat just to move it out of the shop. Almost as large as that lathe.
My little $6 spending spree? 1" chisel, 25' Powerlock tape, an Atkins skewback, 7ppi croscut,and a Starrett 19" long caliper. I didn't even have a motor that could run that line shaft for the lathe. Oh well, maybe next sale will be better...:rolleyes:
345743
Smaller one did have a motor with it. The other ran off a line shaft
345744
Behind this scrollsaw, there is a part from the line shaft, that also ran this little guy..
345745
American Tool Works, from Cincy, OH Thred box might have held more tooling?
345746
It had a metal working style to it, though..
345747
I didn't even have the room for this...
345748
Nor it's grinder. I did managed to get a few hand tools. Estate sale, in-between my monthly SSI check, of course:mad:
Seems the fellow had quite a shop going on, the garage had two floors/levels. Shelves were filled with handtools of all kinds.
The day I took these pictures, a fellow pulled up with a Bobcat loader on a trailer. He was after the air compressor....large enough he NEEDED the forks on the bobcat just to move it out of the shop. Almost as large as that lathe.
My little $6 spending spree? 1" chisel, 25' Powerlock tape, an Atkins skewback, 7ppi croscut,and a Starrett 19" long caliper. I didn't even have a motor that could run that line shaft for the lathe. Oh well, maybe next sale will be better...:rolleyes: