Roger Lueck
09-11-2016, 2:19 PM
Using Laserworks V6; in the past when I have required a specific sequence in which I wanted parts of a project to be cut or engraved I assigned each part a specific color.
I check the following boxes below "Path Optimize":
"Order of Layer"
"Inside to Outside"
"Auto Determine Start Point and Dir"
I then arranged the colors in the sequence (top to bottom) that I wanted the operation to be performed.
This works fine as long as you have fewer parts than colors that are available.
Is there another method to assign the sequence of engraving and/or cutting of different parts within a project?
Is there a reference document somewhere, in understandable English, that defines/explains what each function listed under "Path Optimize" (as well as other functions in Laserworks) will do?
I check the following boxes below "Path Optimize":
"Order of Layer"
"Inside to Outside"
"Auto Determine Start Point and Dir"
I then arranged the colors in the sequence (top to bottom) that I wanted the operation to be performed.
This works fine as long as you have fewer parts than colors that are available.
Is there another method to assign the sequence of engraving and/or cutting of different parts within a project?
Is there a reference document somewhere, in understandable English, that defines/explains what each function listed under "Path Optimize" (as well as other functions in Laserworks) will do?