Trying to Find a Router Bit

[Mark Blatter]

I am trying to find a double curve ogee router bit for a cabinet door edge. I have checked on most of the tool sites such as Amana and Freud, but they don't have anything close.

Any thoughts on where else to check?

[lowell holmes]

I can't determine what a double curve ogee is. Aren't all ogee's double curve?

There are numerous ogee bitts. Can you draw what you are looking for?

I found one on the following link.

http://www.infinitytools.co.uk/router-bits/ogee-bit/

[Victor Robinson]

Perhaps "cove and bead" is what you mean?

Check the MLCS website. While I wouldn't recommend you buy from there if looking for higher quality bits, but perhaps perusing their index of router bits will give you the correct name for the profile.

[Jay Aubuchon]

Something like this (http://www.carbideprocessors.com/whiteside/profile-router-bits/wavy-edge-router-bits/)?

[Ken Fitzgerald]

Check out the bits at MLSC http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/routerbit.html#edge_forming_anchor . I have purchased bits from them and been completely satisfied. I especially like their Katana series.

[Mark Blatter]

Something like this (http://www.carbideprocessors.com/whiteside/profile-router-bits/wavy-edge-router-bits/)?

That is pretty close Jay, and the closest one I could find. Here is a photo of the edge. What I have seen is that most are a taller vertical bite and what I need is a shorter vertical size and longer horizontal one. I thought about using a raised panel bit, but it just cuts too deep. I believe the total vertical cut is about 3/16".

343341

[Victor Robinson]

That is pretty close Jay, and the closest one I could find. Here is a photo of the edge. What I have seen is that most are a taller vertical bite and what I need is a shorter vertical size and longer horizontal one. I thought about using a raised panel bit, but it just cuts too deep. I believe the total vertical cut is about 3/16".

343341

Check the "door edge" bits at the top of this page:
http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_door.html#door_lip_bits_anchor

[Mark Blatter]

Check the "door edge" bits at the top of this page:
http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_door.html#door_lip_bits_anchor

I checked the mlcs site a couple of times, again today after Ken suggested them, yet missed that one Victor. The 'B' profile looks to be a close, if not exact match. Thanks for the help. Got it ordered and on its way.