Minh Tran
08-22-2016, 7:58 PM
I built stumpynub's router lift (link below) and the design calls for a router to be strapped to a sliding carriage using hose-clamps.
My cuts weren't perfect so the carriage and router mount did not hold the router perpendicular to the table surface (vertical deflection).
I can loosen the hose clamps to re-adjust my router but my router bits are too short to use for reference when I try to use it to square it to the table top.
342805
Router Lift: https://www.youtube.com/watch?v=diAg_uZlb2s
My cuts weren't perfect so the carriage and router mount did not hold the router perpendicular to the table surface (vertical deflection).
I can loosen the hose clamps to re-adjust my router but my router bits are too short to use for reference when I try to use it to square it to the table top.
342805
Router Lift: https://www.youtube.com/watch?v=diAg_uZlb2s