Matt Allan
09-28-2005, 12:42 AM
Told ya I would be back with the DC setup help once I got the layout.. :)
Well going by how I am laying it out, which is pictured below, you can see the connection to the tablesaw will be very simple. To get to the jointer/planer is another thing. (The planer will attached when needed and I just plan on putting a Y and the end of the connection)
To get from the DC to the other side of the wall with the jointer just looking at it I would need to
Go up the wall from the DC 7 feet, turn and go 9 feet across the ceiling above the opening, then jump over to the other side of the wall between the joists space and then down the wall to the Y where I can branch off to the jointer and planer. I count that as 5 90 degree turns though, and a few really close together to jump over the wall.. What is the best way to set this up?
The DC is a delta 1.5HP
Any help is greatly appreciated
http://www.sawmillcreek.org/attachment.php?attachmentid=24041&stc=1
Well going by how I am laying it out, which is pictured below, you can see the connection to the tablesaw will be very simple. To get to the jointer/planer is another thing. (The planer will attached when needed and I just plan on putting a Y and the end of the connection)
To get from the DC to the other side of the wall with the jointer just looking at it I would need to
Go up the wall from the DC 7 feet, turn and go 9 feet across the ceiling above the opening, then jump over to the other side of the wall between the joists space and then down the wall to the Y where I can branch off to the jointer and planer. I count that as 5 90 degree turns though, and a few really close together to jump over the wall.. What is the best way to set this up?
The DC is a delta 1.5HP
Any help is greatly appreciated
http://www.sawmillcreek.org/attachment.php?attachmentid=24041&stc=1