Seann Fordham
08-17-2016, 8:00 AM
Hello, I recently posted here about Speedy 300 flexx at work causing bad quality engraving which we recently fixed (3rd mirror was bad) and it's been engraving excellent quality ever since replacing.
I now have a question about the air assist. If I use the 1.5" lens, the air assist will work as intended, but if I flip the brass screw in order to insert a larger lens (2.85" flexx) the air assist won't work as well as it should anymore, maby only 20% of the air will escape from the nose cone (this is using the narrow nose cone). My guess would be the brass screw that screws into the bottom of the head is blocking the slot where the air comes out of, not sure why it would be designed like that, but is the only reason i can think of.
It's not really a major issue, usually just to stop certain materials flaming up when cutting without having to do several passes.
Any advice would be appreciated, thanks.
I now have a question about the air assist. If I use the 1.5" lens, the air assist will work as intended, but if I flip the brass screw in order to insert a larger lens (2.85" flexx) the air assist won't work as well as it should anymore, maby only 20% of the air will escape from the nose cone (this is using the narrow nose cone). My guess would be the brass screw that screws into the bottom of the head is blocking the slot where the air comes out of, not sure why it would be designed like that, but is the only reason i can think of.
It's not really a major issue, usually just to stop certain materials flaming up when cutting without having to do several passes.
Any advice would be appreciated, thanks.