Powermatic #25 Shaper

[Russell Voss]

Hi all, I recently purchased a Powermatic #25 shaper equipped with a drum style reversing switch with is a dual voltage 230/115V motor. When purchased the motor was wired for 230V, but I would like to convert it to 115V. The motor has a diagram for the conversion, but is not accurate because of the reversing switch. I have 6 leads coming out of the switch into the motor, 2 oranges, 2 yellows, and 2 blacks. After removing the cover of the switch, it appears the blacks are the lines, but I have no idea what to do with the other wires. Currently wired at 230V I have the following configuration

Orange- wires 3 and 2
Orange - wire J
Yellow - wire 5
Yellow - 8

I'll get some pictures tonight and post which wires the blacks are hooked up to. Any help would be appreciated.

[rudy de haas]

My bandsaw was the floor model at busybee in Calgary so it came wired for 110V - my best advice on your situation is to do what I did: buy a friend who happens to be a journeyman electrician, a beer (or, in his case, more than one). My saw is now 220V and I have no safety concerns about its power supply.

[Russell Voss]

342371 All, this is the motor plate. The black wires are hooked to the 1 and 4 wires

[David L Morse]

The Orange wire that is connected to 3 and 2 should be changed to 3 and 1 (and the Black wire that's already connected to 1).

The Orange wire that is connected to J should be changed to J and 2.

Do the above one step at a time in that order to avoid reversing the two Orange wires, otherwise FWD & REV becomes REV & FWD.

[Russell Voss]

Thanks David. I'll give that a try tonight!

[Ronald Mancini]

If it possible leave it at 230 because the motor will start much better.

[Russell Voss]

Thanks for your help David, got it going tonight.

[lowell holmes]

What in blazes is a "drum style reversing switch"? :confused:

[Russell Voss]

342467It's very nice for using cutter which require reverse rotation