Mason Atom
08-15-2016, 12:53 PM
Does anyone have an installer for LaserWork/RDCam 5.021?
A few months back I installed a new version of LaserWork and my cutter has not worked properly since then. At the beginning of a job the laser head will randomly jerk about 1 to 3 inches left or right on the x-axis before starting to engrave or cut. After this initial dislocation the instrument cuts and engraves perfectly fine. I have checked and re-checked all of the mechanical workings of the laser (belts, tension, pulleys, teeth, steppers) and the power supply and they all seem to be in order. I tried to roll back to RDCam version 5.027 (available on the Ruida website), but that didn't solve the matter. I would like to see if rolling back to the original (5.021) will fix things but I can no longer find my install disk.
The cutter is a Chinese Artsign 6030.
Thanks for any assistance you can give.
Mason
A few months back I installed a new version of LaserWork and my cutter has not worked properly since then. At the beginning of a job the laser head will randomly jerk about 1 to 3 inches left or right on the x-axis before starting to engrave or cut. After this initial dislocation the instrument cuts and engraves perfectly fine. I have checked and re-checked all of the mechanical workings of the laser (belts, tension, pulleys, teeth, steppers) and the power supply and they all seem to be in order. I tried to roll back to RDCam version 5.027 (available on the Ruida website), but that didn't solve the matter. I would like to see if rolling back to the original (5.021) will fix things but I can no longer find my install disk.
The cutter is a Chinese Artsign 6030.
Thanks for any assistance you can give.
Mason