jim jones 2
08-14-2016, 7:30 PM
Hi all,
I have aquired a Jet Pin Router POR 22. I understand that it is an Asian model imported by Jet. The spindle is pneumatic, and has a worm gear that allows for added adjustment, by moving the spindle along a way.The pin holder sits below the table and is bolted in place with two bolts. The pin protudes through the a larger hole in the table. The pin sits in the center of a bearing, and the bearing is in a holder that adjust up and down via a worm gear; and locks in place with a set screw.
I have tried several times to align the pin with the bit, but just can't get it right. Any one have any insight?
Thanks in advance for your assistance.
Jim
I have aquired a Jet Pin Router POR 22. I understand that it is an Asian model imported by Jet. The spindle is pneumatic, and has a worm gear that allows for added adjustment, by moving the spindle along a way.The pin holder sits below the table and is bolted in place with two bolts. The pin protudes through the a larger hole in the table. The pin sits in the center of a bearing, and the bearing is in a holder that adjust up and down via a worm gear; and locks in place with a set screw.
I have tried several times to align the pin with the bit, but just can't get it right. Any one have any insight?
Thanks in advance for your assistance.
Jim