View Full Version : Taig Mill to make flash hiders?
Thomas Margula
07-10-2016, 3:19 PM
I am trying to figure out what type of machine I would need to make flash hiders? Would a Taig Mill do the job?340481
Bruce Page
07-10-2016, 3:43 PM
One off or production quantities? I think you could buy them cheaper than you could make them but yeah, depending on design & tolerances, a Taig and a small lathe could handle it.
Thomas Margula
07-10-2016, 4:51 PM
One off or production quantities? I think you could buy them cheaper than you could make them but yeah, depending on design & tolerances, a Taig and a small lathe could handle it.
Production quantities.
Bruce Page
07-10-2016, 7:02 PM
Are they typically made of steel or aluminum?
If steel, then I don't think a Taig could do production quantities. At least not very fast.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.