Mark Baldwin III
06-30-2016, 7:17 PM
I just finished a veneer roller for fellow Creeker, Ralph Boumenot.
The roller is 1.5" diameter, 3" wide, 360 Brass. The frame and axle are 304 Stainless. Hardware is stainless and includes two thrust washers to prevent rubbing between the frame and roller. Ralph is making his own handle, so it it's a little incomplete.
The roller is 1.5" diameter, 3" wide, 360 Brass. The frame and axle are 304 Stainless. Hardware is stainless and includes two thrust washers to prevent rubbing between the frame and roller. Ralph is making his own handle, so it it's a little incomplete.