PDA

View Full Version : Veneer Roller



Mark Baldwin III
06-30-2016, 7:17 PM
I just finished a veneer roller for fellow Creeker, Ralph Boumenot.
The roller is 1.5" diameter, 3" wide, 360 Brass. The frame and axle are 304 Stainless. Hardware is stainless and includes two thrust washers to prevent rubbing between the frame and roller. Ralph is making his own handle, so it it's a little incomplete.

Carroll Courtney
07-02-2016, 4:06 PM
That is awesome looking and with the thrust bearings I bet it will last several lifetimes.Now your friend is under alot of pressure,he has to make a handle worthy for that roller.Thanks for sharing,dang that looks good---------------Carroll

Mark Baldwin III
07-03-2016, 9:31 AM
Thank you, Carroll. You are far too kind.