Bob Oswin
09-22-2005, 2:41 PM
I was fortunate to locate an Excalibur EXBC Overarm Blade Cover today and am installing it on my table saw.
I have two sets of instructions ;
One from the original purchase and one off the net.
I can't seem to see how the linkage to the column braces is set up to the vertical leg. The new instructions refere to eyebolts to align the cover.????
I could sure use a picture from one o you kind fellows.
Regards
Bob
I have two sets of instructions ;
One from the original purchase and one off the net.
I can't seem to see how the linkage to the column braces is set up to the vertical leg. The new instructions refere to eyebolts to align the cover.????
I could sure use a picture from one o you kind fellows.
Regards
Bob