Buddy Stevens
06-06-2016, 8:27 AM
First post as a new member, been lurking for a while.
Got an issue hopefully the experts here can help with. Running RDworks 8.00.27with a Chinese 50w blue & white and rotary. With start point in center.
Was cutting great yesterday until we had the power go off. Laser wasn't cutting but it was powdered on. Turned everything off before power came on.
Now today everything we cut is 'flattening' the right side. Moving start point back to a corner and it cuts fine, that just makes it more complicated figuring out how to place piece so design is centered.. I've reset the laser as well.
Any advice?
Got an issue hopefully the experts here can help with. Running RDworks 8.00.27with a Chinese 50w blue & white and rotary. With start point in center.
Was cutting great yesterday until we had the power go off. Laser wasn't cutting but it was powdered on. Turned everything off before power came on.
Now today everything we cut is 'flattening' the right side. Moving start point back to a corner and it cuts fine, that just makes it more complicated figuring out how to place piece so design is centered.. I've reset the laser as well.
Any advice?