Rick Johnston
05-15-2016, 9:47 AM
Getting ready to install the kit. I'm out about 8 thousandths. Three bolts are at the saw front - Do I need to just barely loosen these three prior to adjusting? The instructions seem to indicate that unless the saw is way out of alignment that is not necessary.
After making the adjustment with PALS I'd want to snug those front bolts dn even if I never loosened them up in the first place. Then double check again after all bolts are tight.
After making the adjustment with PALS I'd want to snug those front bolts dn even if I never loosened them up in the first place. Then double check again after all bolts are tight.