PALs / Sears contractor saw

[Rick Johnston]

Getting ready to install the kit. I'm out about 8 thousandths. Three bolts are at the saw front - Do I need to just barely loosen these three prior to adjusting? The instructions seem to indicate that unless the saw is way out of alignment that is not necessary.

After making the adjustment with PALS I'd want to snug those front bolts dn even if I never loosened them up in the first place. Then double check again after all bolts are tight.

[Andy Haney]

It has been way too long since I installed mine and I no longer have that saw. However, I think it may be best to check with Jerry at In-Line. He should be able to give you the best answer.
http://in-lineindustries.com/products/contractor-saw-pals/

[Cary Falk]

I would loosen 2 of the 3 in the front so it pivot on the 3rd. Then tighten all of them when you get it adjusted.